fbpx
- 40%

LM2596S DC-DC LM2577S Step Up Down Boost Buck

24 sold

৳ 300.00

Available : 9 Sold : 24

9 in stock

SKU: 2412 Categories: ,

  • This module power output is affect by the module itself-capacity and pre-and post-class load and other factors; the following data for professional equipment measured results, without considering other factors.
    Power supply module is a kind of electronic components, please don’t buy the item if you have no electronic expertise.
    This Module Properties: It is non-isolated step-down constant current, constant voltage module (CC CV) charging module

Specification:

  • Input Voltage :4-35V
  • Output voltage: Continuously adjustable(1.25-25V unload adjust)
  • Output current: 3A Max(If more than 15W, please install the heat sink)
  • CC range :0-2A (adjustable)
  • Revolving light current: CC value * (1%-100%), default is 0.1 times
  • Minimum voltage difference: 2V
  • Output power: natural cooling 15W
  • Conversion efficiency: 80% (the higher the output voltage, the higher the efficiency)
  • Operating Temperature: Industrial (-40 C to +85 C) (ambient temperature more than 40 C, lower power use, or add heat sink)
  • Full load temperature rise: 45 C
  • Indicator: CC indicator is Red, charging indicator is Red, charging completed the indicator is Blue.
  • Output short circuit protection: Yes, constant current.
  • Connect method: Can solder on the PCB with wire directly
  • Input: IN+ input Positive is, IN- input negative
  • Output: OUT+ output is positive, OUT- output negative
  • Module Size: 50 x 37 x 13mm

Some Applications:

  • High-power LED constant current driver.
  • Lithium batteries (including ferroelectric), 4V, 6V, 12V, 14V, 24V battery charging, nickel-cadmium nickel-metal hydride batteries (battery) charge.
  • Solar panels, wind generator voltage regulator circuit board power supply, such as automatic buck regulator circuit.

Battery use:

  • Make sure of the voltage and current of the battery you need to charge
  • Adjust the constant voltage potentiometer to make sure the output Voltage is about 5V(about).
  • Use the multimeter in 10A current scale to measure output short-circuit current, and adjust the current potentiometer to make sure the output current to the expected charging current value
  • The charge current of transfer lamp is default 0.1 times of the charging current (constant current value)
  • Adjust the constant voltage potentiometer to make sure the output Voltage is up to floating Voltage.
  • Connected to the battery and try to charging (for previous 5 steps, module input terminal is connected to power source, output load is NOT connected to batteries).

LED Constant Current Driver Use:

  • Make sure operating current and Max operating Voltage of the LED you need to drive.
  • Adjust the constant voltage potentiometer to make sure the output Voltage is 5V(about).
  • Use the multimeter in 10A current scale to measure output short-circuit current, and adjust the current potentiometer. To make sure the output current to the expected LED operating current.
  • Adjust the constant voltage potentiometer to make sure the output Voltage is up to LED Max operating Voltage.
  • Join LED, test (For the above 3 steps, module input terminal is connected to power source, output load is NOT connected to LED).
  • aeProduct.getSubject()